SiC/CVD SiC复合涂层的抗氧化及抗热震性能研究

为了提高C/SiC复合材料耐高温性能,采用泥浆浸渍裂解与真空化学气相沉积(CVD)在材料表面制备了SiC/CVD SiC复合涂层,通过XRD、SEM分析了涂层组成与结构;研究了复合涂层的高温抗氧化(700～1 500℃)和抗热震性能。结果表明,泥浆浸渍法制备的SiC涂层具有一定的封孔效果,可使材料开孔率下降,但高温抗氧化效果并不佳,1 200℃氧化10 min后材料弯曲强度保留率下降明显仅有86%。CVD SiC涂层结构致密,与SiC封孔涂层结合较好,在700～1 500℃具有较好的抗氧化效果,随着氧化温度的升高,氧化后涂层完好,表面O元素逐渐增加,材料失重率缓慢增加但不大于0.5%,且材料性能并未下降。涂层材料在1 200℃-10 min短时热震5次后材料弯曲强度保留率仍有95%以上,且未出现开裂、剥落等热震损伤。在1 200℃-30 min长时热震10次后,涂层材料基本被完全氧化,材料失去保护作用,弯曲强度下降至90%左右。     

Effect of moderate geomagnetic storms on equatorial plasma bubbles over eastern Africa in the year 2012: Evolution and electrodynamics

Equatorial plasma bubbles (EPBs) are common features of the equatorial and low-latitude ionosphere and are known to cause radio wave scintillation which leads to the degradation of communication and navigation systems. Although these structures have been studied for decades, a full understanding of their evolution and dynamics remains important for space weather mitigation purposes. In this study, we present cases of EPBs occurrences around April and July 2012 geomagnetic storm periods over the African equatorial sector. The EPBs were observed from the Communications/Navigation Outage Forecasting System (C/NOFS) and generally correlated well to the ionospheric irregularities observed from the Global Positioning System total electron content (GPS-TEC) measurements (rate of TEC change, ROT). This study revealed that the evolution of the EPBs during moderate storms is controlled by the strength of the daytime equatorial electrojet (EEJ) currents regardless of the strength of the equatorial ionization anomaly (EIA), the latter is observed during the July storm case in particular. These effects were more evident during the main and part of the early recovery phases of the geomagnetic storm days considered. However, the evening hours TEC gradients between regions of the magnetic equator and ionization crests also played roles in the existence of ionospheric irregularities.     

Global ionospheric scintillations revealed by GPS radio occultation data with FY3C satellite before midnight during the March 2015 storm

Global observations of S4 amplitude scintillation index by the GPS Occultation Sounder (GNOS) on FengYun-3 C (FY3C) satellite reveal global dynamic patterns of a strong pre-midnight scintillations in F-region of the ionosphere during the St. Patrick’s Day geomagnetic super storm of 17–19 March 2015. The observed strong scintillations mainly occurred in the low latitudes, caused by equatorial plasma bubbles. During the main storm phase (March 17), the scintillations were first triggered in the New Zealand sector near 160°E longitudes, extending beyond 40°S dip latitude. They were also enhanced in the Indian sector, but significantly suppressed in East Asia near 120°E longitude and in Africa around 30°E longitude. During the initial recovery phase (March 18–19), the global scintillations were seldom observed in GNOS data. During the later recovery phase (after March 19), the scintillations recovered to the pre-storm level in Indian, African, and American sectors, but not in East Asian and any of Pacific sectors. These results closely correlate with observations of the density depletion structures by the Communication/Navigation Outage Forecasting System (C/NOFS) satellite, and ground-based instruments. Such consistency indicates reliability of our scintillation sensing approach even in a case-by-case comparison study. The prompt penetration electric field and disturbance dynamo electric field are suggested as the main factors that control the enhancement and inhibition of the scintillations during the storm, respectively.     

C/SiC材料主被动氧化烧蚀机理及计算方法研究

基于热化学平衡方法建立了任意比例C/SiC材料的主被动氧化烧蚀模型，开展了C/SiC材料氧化烧蚀机理的计算研究，并基于典型材料烧蚀试验结果进行了充分验证。计算结果表明，C/SiC材料的氧化烧蚀特性取决于表面温度、氧分压以及组分等因素，可能会出现主动氧化和被动氧化两种破坏机制，目前的烧蚀模型能够预测出任意比例C/SiC材料两种氧化烧蚀机制的转换过程；SiC含量对C/SiC材料的氧化烧蚀特性有明显的影响，随着SiC含量的提升，主/被动氧化转换临界分压会减小，材料的抗氧化性能越好；但当材料均处于主动氧化阶段时，SiC含量越高材料的无量纲烧蚀速率越大，材料的抗烧蚀性能减弱。     

结冰对民用飞机飞行性能的影响分析

在获取民用飞机适航合格审定证明前,必须通过飞行试验,并在试验中演示验证民用飞机能在CCAR25部附录C确定的连续和间断的最大结冰状态下安全运行。基于此背景,计算并得到某型机两种构型在45min待机冰型下的飞行性能,与无冰状态下对应构型的飞行性能进行对比分析。结果表明,结冰对飞机的飞行性能具有较大的影响。     

7000系高强铝合金的发展及其在飞机上的应用

阐述了7000系高强度铝合金的国内外发展现状,列举了高强度铝合金在国外飞机上的应用情况,指出了目前国内飞机用高强铝合金材料存在的问题,并对高强铝合金在未来飞机机体的选用提出了建议,供设计人员参考使用。     

航天测控系统自主运行的关键技术

航天事业发展趋势和未来需求指明,航天测控系统应该向以自主运行能力为代表特征的智能化方向发展。基于此,提出了标准化的支持与服务、映射现实的体系架构、实时响应的运行模式、服务化的基础平台等4项关键技术。通过将测控系统和卫星系统之间的接口、测控系统和用户系统之间的接口标准化,从而在此基础上建立最优化的操作逻辑。通过在计算机中映射现实系统的思想方法,从而产生稳定性和灵活性兼备的、支持自主运行的,并具有良好进化性能的系统架构。通过实时响应的运行模式可以很好满足全时段和突发性等具有挑战性的测控服务需求。通过大数据和云计算技术构建基础计算服务平台实现基础层与业务层分离,有利于整个系统的持续改进,提高服务质量改善的速度,建立竞争力优势。由此说明,在当前技术条件下实现自主运行的航天测控系统是可行的。     

直扩测控系统抗多址能力分析与验证

为了防止多址干扰造成接收机出现误捕和假锁,改善直接序列扩频测控系统抗多址干扰性能,在Gold码特性和扩频接收机性能分析的基础上,结合最大似然原理,对采用扩频体制测控系统的抗干扰能力进行了分析。为契合工程应用,采用仿真遍历结合理论分析的方式,对Gold码的互相关抑制能力理论值进行了工程修正。在分析捕获阶段的抗干扰捕获门限后,还分析了载噪比估计结果在正常锁定和假锁两种状态下的差异,给出了接收机对假锁状态的判决方法和门限。根据分析和仿真的结果,给出了系统设计约束条件和优化的接收机设计流程,作为测控系统和接收机设计的参考。     

基于SRAM型FPGA单粒子效应综合防护技术

为解决基于SRAM(Static Random Access Memory,静态随机存储器)型FPGA(Field Programmable Gate Array,现场可编程门阵列)的扩频应答机在空间环境中时常发生功能故障的难题,提出了一种低轨卫星基于SRAM型FPGA的应答机的单粒子综合防护方案。该方案在代码级、器件级、单机级、整星级综合采用器件优选、结构屏蔽设计、巡检自愈、自主复位等多种方法,有效杜绝了单粒子事件带来的种种危害,已成功应用于某在轨卫星。在轨测试结果表明:遥测、遥控、跟踪测量等功能、性能指标满足任务要求,且未发生需要地面干预的问题或现象。该技术还可推广应用于其他采用低等级器件及其他类型FPGA、DSP(Digital Signal Processing,数字信号处理)等大规模集成电路的星载单机防护。     

测控雷达伺服系统整流电路的建模与仿真

电力电子整流电路是测控雷达伺服系统的重要组成部分。某型测控雷达采用了三相零式反并联可逆整流电路结构。分析了整流电路可逆运行的工作原理以及晶闸管触发电路的控制方式,利用MATLAB/Simulink的建模功能,建立了触发脉冲产生电路和整流电路的模型,仿真得出系统可逆运行时电机的工作状态以及整流电路输出电压波形。仿真结果显示,此整流电路可以实现电机的四象限运行,所建模型正确。利用该模型可以对测控雷达伺服系统的分析和设计起到很好的辅助作用。